GTS06-OC-RA400A-2M Енкодер

Incremental Optical Rotary Encoders with 6mm Shaft / 400 Pulses / 1600 Quadrature Pulse / Push Pull Output Type/ AB Signals

Price without tax:37,86 лв

Ask a question about this product Back to: Eнкодери

Details

Details

TECHNICAL Details and Specifications

_{Pictures, dimensions,table data and technical drawings of this product are made with reasonable care and liability is excluded for the accuracy and correctness of this data.}

Specifications			Details
Item			Diameter 38mm shaft 6mm type incremental rotary encoder
Resolution (p/rev)			400ppr / Quadrature Pulse 1600ppr
	Output Phase		AB Phase
	Output Type		Push Pull Output
	Electrical	SupplyVoltage	5-24VDC
		Current Consumption	Max. 40mA
		Response Frequency	Max. 20Khz
		Allowable Revolution	Max. 3000 rev/min
	Mechanical	Starting Torque	Max. 20gf.cm (0.002N.m)
		Rotor Interia	Max. 15g.cm2(1.5*10-6kg.m2)
		Shaft Loading	Radial: Max. 2kgf Thrust: Max. 1kgf
		Mechanical Speed	Max. 5000 rev/min
	Environmental	Ambient Temperature	-10~70 (at non-freezing status), Storage:-25~85
		Ambient Humidity	35~85%RH, Storage: 35~90%RH
		Protection	IP52 (IEC standard)
		Vibration	1.5mm amplitude at frequency of 10-55 Hz in each of X,Y, Z direction for 2 hours.
		Shock	Max. 40G
Unit Weight			Approx: 180g
Cable Lenght			2.0m (The cable length can be customized by request)
Approval			CE ROHS
Model			GTS06-OP-RA400A-2M

WIRING

Do not cut or connect circuit when power is ON, it may cause damage to the unit. When the power source is Switching Power, it may cause surge. Install a surge absorber in Power line. Wire should be shorter in order not to be influenced by noise. Do not splash water, oil etc, cover the protecting hood when necessity.

Do not pull out the wire with over 30N strength after fixing the unit and wiring the cable. If wire encoder cable with high voltage line or power cable in the same conduit, it may cause a Malfunction or mechanical problem. Please wire it separately or use separated conduit.

Encoder Wire Colors and Signals
Signal	VCC	GND	A	B	Shield
Color					Shield

RECOMMENDATIONS

Vibrations: if a big impact or strong vibration applies to the product it may cause pulse errors. Be careful by installing this unit. Encoder with high resolution can be easily affected by vibration, therefore tighten fixing bracket when installing this unit.
When you install this unit, if eccentricity and deflection angle are larger, load is applied to the shaft, it may shorten the life cycle of this unit.
This unit consists of precision components. If you drop this unit, it may lose the function. Please treat this product carefully.
Keep this device away from strong vibrations or it may be damaged.
Keep this device away from strong vibrations or it may be damaged.
Keep this device away from the place where there is a lot of flammable or corrosive gases.
Keep this device away from strong magnet field while electric noise can occurs.
Keep this device away from place where there is the direct ray of the sun.
Do not use this device beyond of the rated temperature or humidity.
Do not use this device in place where strong acids or alkali are used.
Do not put strong impact with hammer, etc when insert coupling into shaft.

DIMENSIONS

encoder

PACKAGE Includes

(1pcs) / GTS06-OP-RA400A-2M Encoder with 2m cable
(3pcs) / M3 * 8mm Screws for Assembly