TECHNICAL Details and Specifications
Pictures, dimensions,table data and technical drawings of this product are made with reasonable care and liability is excluded for the accuracy and correctness of this data.
|Item||Diameter 38mm shaft 6mm type incremental rotary encoder|
|Resolution (p/rev)||400ppr / Quadrature Pulse 1600ppr|
|Output Phase||AB Phase|
|Output Type||Push Pull Output|
|Current Consumption||Max. 40mA|
|Response Frequency||Max. 20Khz|
|Allowable Revolution||Max. 3000 rev/min|
|Mechanical||Starting Torque||Max. 20gf.cm (0.002N.m)|
|Rotor Interia||Max. 15g.cm2(1.5*10-6kg.m2)|
|Shaft Loading||Radial: Max. 2kgf Thrust: Max. 1kgf|
|Mechanical Speed||Max. 5000 rev/min
|Environmental||Ambient Temperature||-10~70 (at non-freezing status), Storage:-25~85|
|Ambient Humidity||35~85%RH, Storage: 35~90%RH|
|Protection||IP52 (IEC standard)|
|Vibration||1.5mm amplitude at frequency of 10-55 Hz in each of X,Y, Z direction for 2 hours.|
|Unit Weight||Approx: 180g|
|Cable Lenght||2.0m (The cable length can be customized by request)|
Do not cut or connect circuit when power is ON, it may cause damage to the unit. When the power source is Switching Power, it may cause surge. Install a surge absorber in Power line. Wire should be shorter in order not to be influenced by noise. Do not splash water, oil etc, cover the protecting hood when necessity.
Do not pull out the wire with over 30N strength after fixing the unit and wiring the cable. If wire encoder cable with high voltage line or power cable in the same conduit, it may cause a Malfunction or mechanical problem. Please wire it separately or use separated conduit.
|Encoder Wire Colors and Signals|